Phoenix Contact D-SUB combination contact insert - VS-25-ST-DSUB-4P-5S-LH - 1655409
Product Description:
D-SUB combination contact insert, number of positions: 9, material: Steel, tin-plated, connection method: Solder connection, size of housing: 3
Technical Info
GTIN
: 04046356029339
Series
: VS-25-ST-DSUB-4P-5S-LH
Type
: D-SUB-combinatiecontactblok
Key Features
- D-SUB combination contact insert
- number of positions: 9
- material: Steel
- tin-plated
- connection method: Solder connection
- size of housing: 3
Training Data Goes here
Mechanical characteristics
Connection method
Solder connection
Overvoltage category
III
Degree of pollution
2
Weight
13.92 g
Flammability rating according to UL 94
V0
Ambient conditions
Ambient temperature (operation)
-55 °C ... 130 °C
Material data
Contact surface material
Gold over nickel
Contact material
Copper alloy
Contact carrier material
PBT-GF
Housing material
Steel, tin-plated
Mounting type
4-40 UNC thread
Electrical characteristics
Number of positions
9
Rated current
5 A (at 20 °C (signal contacts))
Rated voltage (III/3)
250
Test voltage
1200
Insulation resistance
≥ 5 GΩ
Standards and Regulations
Safety note
WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
Safety note
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
Safety note
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
Safety note
• The products are suitable for applications in plant, controller, and electrical device engineering.
Safety note
• When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
Safety note
• Assembled products may not be manipulated or improperly opened.
Safety note
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
Safety note
• When using the product in direct connection with third-party manufacturers, the user is responsible.
Safety note
• For operating voltages > 50 V AC, conductive connector housings must be grounded
Safety note
• Only use tools recommended by Phoenix Contact
Safety note
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
Safety note
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
Safety note
• Operate the connector only when it is fully plugged in and interlocked.
Safety note
• Operate the connector only when it is fully plugged in.
Safety note
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
Safety note
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
Safety note
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
Environmental Product Compliance
REACh SVHC
Lead 7439-92-1
China RoHS
Environmentally Friendly Use Period = 50 years
EAC B.01687
