Product Description:
Adapter plates 2 mm thick, for panel cutouts of HC-B 24 size, including 1.5 mm flat gasket, size 2
Technical Info
GTIN
: 04017918178611
Series
: HC-B 24-ADP-VC-C2
Type
: Adapterplaat
Key Features
- Adapter plates 2 mm thick
- for panel cutouts of HC-B 24 size
- including 1.5 mm flat gasket
- size 2
Training Data Goes here
General
Material
V2A
Type
VC2
Standards and Regulations
Safety note
WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
Safety note
WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
Safety note
WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
Safety note
The products are suitable for applications in plant, controller, and electrical device engineering.
Safety note
When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
Safety note
Assembled products may not be manipulated or improperly opened.
Safety note
Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
Safety note
When using the product in direct connection with third-party manufacturers, the user is responsible.
Safety note
For operating voltages > 50 V AC, conductive connector housings must be grounded
Safety note
Ensure that the protective or functional ground has been properly connected.
Safety note
VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
Safety note
Observe the corresponding technical data. You will find information:o On the product On the packing label In the supplied documentation Online at phoenixcontact.com/products under the product
Safety note
Only use tools recommended by Phoenix Contact
Safety note
The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
Safety note
Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
Safety note
Operate the connector only when it is fully plugged in.
Safety note
Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
Safety note
Observe the minimum bending radius of the cable. Lay the cable without twisting it.
Environmental Product Compliance
China RoHS
Environmentally friendly use period: unlimited = EFUP-e
China RoHS
No hazardous substances above threshold values
There is no certificate available for this product.
There is no accessory available for this product.
